Naxa NPB-429 Manuel du propriétaire Page 6

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 9
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 5
5
VOLUME ADJUSTING
Rotate the VOLUME button to increase or decrease the volume.
RADIO OPERATION
TUNING IN RADIO STATIONS
1. Press the FUNC. button to RADIO mode.
2. Press the MO/ST button l to select the FM/FM ST.
3. Tune to preferred radio station by Press the CD SKIP UP/DOWN /TUN UP/DOWN button, the
display will show the band frequency. Example: FM 97.9 MHz
4. Rotate the VOLUME CONTROL to comfortable volume level.
5. Extend FM TELESCOPIC ANTENNA to its full length if you are listening to FM broadcasting.
Note: When you are receiving FM stereo program, the “STEREO” shows steady on the display.
6. To turn off the radio, press the FUNC. button to CD, AUX or USB operation, or switch off the unit by
pressing the STANDBY button.
RADIO AUTO SCAN (SEARCH)
Press and hold the button for about 2 seconds, the unit will conduct auto scan and program until
having found a strong signal. The unit will start to broadcast the P01 after searching finished. Press the
CD SKIP UP/DOWN or TUN. UP/DOWN button to choose next programmed station.
RADIO STATION MEMORY OPERATION
You may pre-store 20 (FM and FM ST.) radio stations in memory for your preference controlled by press
the MEM button , so as you can listen to your desired station directly and quickly, no need to tuning and
search for again.
1. Press the FUNC. button to RADIO mode..
2. Press CD SKIP UP/DOWN or TUN. UP/DOWN button to select (FM or FM ST.), Tune into a
station.
3. Press MEM button the “P01 ”shows on the display. Then press the M+ or
M- button to select the
fi
rst storing location.
4. Press MEM button again to store.
5. Search another station, repeat steps (2) & (3) until all desired stations stored. Up to 20 stations can be
programmed.
6. Press M+ or M- button to listen to
the stored station directly.
CD/MP3 OPERA
TION
Discs for Playback
This system can playback all digital audio CD/MP3, finalized digital audio CD-Recordable (CD-R) discs,
finalized digital audio CD-Rewritable (CD-RW) discs and CD-DA format digital audio
CD/CD-R/CD-RW discs.
LOADING A DISC
1. Press the FUNC. button to CD mode.
2. Press the PUSH TO OPEN button to open the CD door, “ ” will be shown on the display.
3. Place an audio CD/MP3 DISC into the tray with the front side facing up.
4. Close the CD door.
The display will show a flashing “ - - ”, then the total number of tracks would be shown and the
playback will starts from the first track.
5. To remove the CD, press PUSH TO OPEN button to open CD door, the display will show ”.
Hold the CD by its edges, and carefully take it out.
Vue de la page 5
1 2 3 4 5 6 7 8 9

Commentaires sur ces manuels

Pas de commentaire